, , ,

T39-JD08 Soldering Iron Tip – Bent

SKU: HT39-JD08

Availability:

In stock


Hakko soldering iron tip used with the FX9701 / FX9702 soldering iron used with the FX971 and FX972 Soldering Stations
T39 Composite Tip design includes the sensor within the tip allowing for faster more accurate thermal adjustments and greater stability.

£18.29 Excl. VAT

In stock

A minimum sub total of £250.00 is required, You need an additional £250.00 to proceed through to the checkout.

For customers in the Republic of Ireland, please contact us for a quote including shipping and customs charges.

Request quote
How to use Shape J and examples

This shape differs from Shape B and I by bending the tip end and is capable of soldering by applying the tip in 2 ways: face and point. It is used for drag soldering and correction of bridging.


Soldering tiny chip parts such as 0603
Soldering tiny chip parts such as 0603Lay down the end pad section and put the tip to the land.
* Soldering tip in the picture is T30-J with an N2 system iron for pre-heating effect.

Some IC is specified by manufacturer not to be touched electrode by tip end.

 

The other tip shapes are recommended.
Soldering tiny chip parts such as 0603


Drag soldering
Use it for drag soldering.Lay down the end pad section and drag the tip slowly.

Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.

 

Check the right timing to feed solder.


Correcting Bridging
Use it for correcting Bridging.If the bridge amount is small

Stand the tip on end and drag the tip slowly.

Please operate with clean tip.

 

Use it for correcting Bridging.

If the bridge amount is large

Lay down the end pad section and drag the tip slowly while putting the tip on the solder in the bridged section.

Please operate with clean tip.

 

The operating bellow is also available.
The operating bellow is also available.

Soldering at the narrow pitches
Use it for soldering tiny chip parts such as 0603.
Enlarge the tip end,
You can hold the grip with the natural angle (Refer to A) while soldering with Shape J, which has the same high-angle of tip end (Refer to B) as Shape I.

Use it for soldering tiny chip parts such as 0603.Use it for soldering tiny chip parts such as 0603.
Shape JShape I