T11-D4 Chisel Tip
, , , ,

T11-D4 Chisel Tip

SKU: HT11-D4

Hakko
Availability:

In stock

T11-D4 replacement chisel tip for the FX-901 Cordless Soldering Iron

£19.30 Excl. VAT

In stock

A minimum sub total of £250.00 is required, You need an additional £250.00 to proceed through to the checkout.

For customers in the Republic of Ireland, please contact us for a quote including shipping and customs charges.

Request quote

How to use Shape D and examples

This shape is capable of any soldering by placing the tip end in 2 ways: line and face. Therefore it requires soldering skill such as Shape B.

H K Wentworth - HAKKO UK and Ireland distributorLine example

H K Wentworth - HAKKO UK and Ireland distributor

Shape D is also available for soldering at narrow pitches by placing the tip end in Line.
T12 series has ten kinds of Shape D which has the variation of Line width from 0.5mm to 1.2mm.

Shape D has the special application of Heavy Duty Type.
Shape D has the special application of Long Life Type.

Soldering tiny chip parts such as 0603

H K Wentworth - HAKKO UK and Ireland distributorPut the tip end to the land.
* Soldering tip in the picture is T30-D06 with an N2 system iron for pre-heating effect.Some IC is specified by manufacturer not to be touched electrode by tip end.

The other tip shapes are recommended.
Soldering tiny chip parts such as 0603

Soldering chip parts

H K Wentworth - HAKKO UK and Ireland distributorPut the tip end to the land and drag the tip slowly while feeding solder.

Some IC is specified by manufacturer not to be touched electrode by tip end.

See the movie for further details,

The other tip shapes are recommended.
Soldering chip parts

Drag soldering

H K Wentworth - HAKKO UK and Ireland distributorPut the tip end to the leads and drag it slowly.

Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.

See the movie for further details,
Check the right timing to feed solder.

The other tip shapes are recommended.
Drag soldering

Pre-tinning lead wire

H K Wentworth - HAKKO UK and Ireland distributorPut the cut surface to the lead and drag the tip slowly while feeding solder.

See the movie for further details,

Point soldering

H K Wentworth - HAKKO UK and Ireland distributorPTH

1. Put the tip end to the land pad and PTH at one time to heat them.

2. Feed solder to form smooth fillet on the land pad.

H K Wentworth - HAKKO UK and Ireland distributorQFP

Put the tip end to the leads and drag it slowly.

See the movie for further details,

The other tip shapes are recommended.
Point soldering

Soldering cup terminals

H K Wentworth - HAKKO UK and Ireland distributor1. Put the cut surface to the lead and terminal at one time to heat them.

2. Feed solder to form smooth fillets.

Get rid of gold plating of terminal and pre-tin lead wire. It makes solder spread over the terminal easily and prevents soldering defect. For further information, see Soldering cup terminals.

Melting and removing coil coatings

H K Wentworth - HAKKO UK and Ireland distributor1. Put the cut surface to the coil and terminal at one time to heat them.

2. Feed solder.

The other tip shapes are recommended.
Melting and removing coil coatings

suitable for HAKKO FX-901 Cordless Soldering Iron

Categories: , , , , Tags: , , , , ,
Weight0.0052 kg