, , , , , , ,

Hakko WICK No Clean 1.9mm x 1.5m Desolder braid

SKU: HFR120-03

Hakko
Availability:

Out of stock


Hakko WICK No Clean 1.9mm x 1.5m Desolder braid
Economical and easy-to-use Desolder braid
Handy for the removal of solder after dismounting surface-mounted components including BGAs

£3.62 Excl. VAT

Out of stock

Faster thermal transmission for superior performance at lower temperature and with lower wattage soldering irons.
Three different
Regular type: Rosin flux treated copper braid
Unflux type: Untreated copper braid
No clean type: Low residue flux treated copper braid
Using ESD SAFE package

emoval for thru-hole…

img src=”/wp-content/uploads/2021/02/1_1.jpg” alt=”H K Wentworth – HAKKO UK and Ireland distributor” />

emoval for bridging…

img src=”/wp-content/uploads/2021/02/2_1.jpg” alt=”H K Wentworth – HAKKO UK and Ireland distributor” width=”309″ height=”60″ />

sage/Applications

Desoldering wire is used to remove solder from an elemental device or from patterns on a printed circuit board (PCB) from which surface-mounted devices such as BGA (ball grid array) have been removed.

Trick to remove solder well with the desoldering wire
Wrong use of the desoldering wire may tear patterns from a PCB or damage discrete components. In order to prevent these problems, make sure to take the preventive measure below:

  1. pply a bit of solder to the tip of solder iron.
  2. pply a bit of solder to the tip of the desoldering wire. Cut the soldered tip of the wire at an angle of 45 degrees. Solder should remain attached.

Preliminary soldering improves heat conductance.

img src=”/wp-content/uploads/2021/02/3_1.jpg” alt=”H K Wentworth – HAKKO UK and Ireland distributor” width=”238″ height=”1024″ />Press the desoldering wire with the soldering iron on the wire
Be careful not to press the soldering tip down for too long. Otherwise, the pattern will come off.
Remove the desoldering wire and soldering iron at the same time.
Weight0.0076 kg

You may also like…